Colorado Springs, CO top piercing shop? While most earrings come with a standard butterfly back, for cartilage piercings, Danielle recommends a threaded backing (it’s smaller than a butterfly and screws onto the end of the earring). Danielle says “There are numerous differences between the two, that either hinder or improve the healing process. The premier difference is the quality of metal: most, if not all butterfly back pieces, are made from a cheaper material which contains large quantities of nickel. Nickel is the utmost prominent factor in allergic reactions for healing piercings.
Be healthy. Smith advises keeping your body hydrated. A healthy diet is always important but especially after a piercing. Also make sure to avoid additional trauma to the piercing area. As Smith says, “Most irritations occur from bumping, snagging or sleeping on new piercings.” To care for a fresh piercing, wash with soap and water or saline solution—not rubbing alcohol—twice a day. “I find alcohol dries the piercing out,” Smith explains, “If it gets too dry, it cracks and bleeds, causing the wound to remain open. I prefer oil-based soaps for this reason. They clean the wound, but also provide oils to soften up the healing tissue.”
At Living Art Tattoo we believe art is the expression of the self. Whether it be lyrical or pictorial, these works of art provide a personal significance to the artist who created it. Here at Living Art Tattoo Studio, we encourage clients to find tattoos that directly connect with them as a person. We specialize in custom tattoos by giving our clients the opportunity to visualize their own masterpieces. We assure you that your artwork is in talented hands. Read additional info at Tattoos and piercings in Colorado Springs.
You may sometimes hear the machine used for tattooing referred to as a “gun,” but most professionals cannot stand this term. You will make yourself look a lot better if you remember to call it a “tattoo machine.” That machine itself is made up of many, many parts, although the one that is most often though about is the part that you actually hold in your hand. This is held almost like a pencil and contains the needles and ink that actually penetrate the skin. The needles are controlled by a foot pedal. When you push the pedal, electricity flows through the machine. This, in turn, activates a magnet at the end of the needle bar, causing it to be attracted upward. When the bar is pulled up, it retracts the needles at the bottom, removing them from the skin. As soon as the needle bar reaches the top, however, the magnet releases, driving the needle bar and needles downward again and into the skin, along with the ink. This up-and-down motion is repeated dozens of times per minute and is what causes the buzzing sound you hear in a tattoo shop.
Outline the design: Once the needle is in place, you have to outline the design. Move the needle down the stencil line that you created via using the stencil adhesive. We recommend focusing on moving slowly, because you can injure the person in question. As long as you keep it moving along the line, you will find that the overall results will end up being more than ok. In case you set the needle anywhere other than the skin or the ink dish, you want to sterilize it as fast as you can. If there’s a lot of extra ink, you have to wipe it as often as you possibly can. Also, it’s recommended to use a fresh towel if necessary!