High quality fuel tank sealer & brake caliper paint online store by Por15? POR-15 Metal Prep provides the best adhesion for POR-15 Rust Preventive Coating on any metal surface, including aluminum and shiny polished metal surfaces. Our simple process gently etches metal, creating an ideal anchor pattern for coatings such as POR-15 Rust Preventive Coating, while simultaneously leaving a zinc phosphate coating to insure chemical bonding of paint and steel. Avoid other preps that may leave harmful residues which prevent proper adhesion. After thoroughly degreasing your work piece, apply environmentally safe POR-15 Metal Prep to both neutralize any rust and etch any clean bare metal. This will allow better adhesion of POR-15 Rust Preventive Coating or any other coating. POR-15 Metal Prep is not caustic, corrosive, toxic or flammable.
POR-15 Alloy Prep Soft Metal Etching Rust Neutralizer (formerly AP-120 Metal Prep) is designed exclusively for use with our 2K Urethane Clear, Alloy Prep guarantees perfect adhesion of 2K Urethane to any metal surface, especially chrome or polished aluminum, where good adhesion is often difficult to achieve and where other solutions may discolor. Alloy Prep is non-flammable with no noxious fumes. Wear rubber or latex gloves when using.
POR-15 Rust Remover will safely remove light to even heavy rust completely from metal surfaces and will not affect plastic, PVC, Viton, or most paints. One gallon derusts several hundred pounds of heavily rusted steel, this equates to around 1/2 to 3/4 pounds of dry rust removed per gallon. Rust Remover will not harm unrusted steel and is safe on other metals. Rust Remover has no fumes or bad odors and no VOCs. No sanding or scrubbing required. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. All of the rusted areas must be submerged in the Rust Remover for it to work. When all of the rust has been removed, rinse the metal pieces with water. POR-15 Rust Remover works in as little as 20 minutes for light rust or overnight for heavy rusted metal. For best results use POR-15 Cleaner Degreaser to clean parts before using POR-15 Rust Remover. Read extra details on rust remover.
Mask off the areas not to be painted. Tape off the brake bleeder screw, brake lines, and caliper piston boots and anything else you don’t want painted. Open the small can of POR-15 Rust Preventive Coating and stir, making sure the contents are thoroughly mixed. Using a foam brush (included in your kit) paint the caliper evenly, making sure the coating is evenly applied but not to the point where the paint runs. Because this is a rust preventive coating you want to be sure you don’t miss any spots which could rust later if not covered.
Rust is caused by moisture coming in contact with metal, which causes a chemical action called oxidation. All paints provide a measure of protection for a while, but since they are eventually softened and weakened by moisture, it is only a matter of time before moisture penetrates the painted surface and attacks the metal below. All of the so-called rust preventive paints on the market (except POR-15) are weakened by exposure to moisture. POR-15 is strengthened by exposure to moisture. Notice the hardness of the POR-15 coating. It doesn’t chip, crack, or peel like ordinary paints do, and its hardness will resist the wear and tear of every day life. See more details at https://por15.com/.